This device is a personal mini heater. I will show you how to make this in less than 10 minutes and $5!
Step 1: Gather Your Supplies
For this, you will need these items:
1. Thin wire (I used 30 gauge wire).
2. A small diameter tube. (I used a thin metal tube from an old air soft gun).
3. Duct Tape (Optional but very helpful)
4. D-Cell battery
Step 2: Start Wrapping the Wire
Start by taping the wire to hold in in place, then wrap around the tube with wires very close together but not on top of one another.
Step 3: Finish Wrapping the Wire
After you're done wrapping, it should look like mine and very close together, it is only a few inches of wrapping, so be sure to not go overboard.
Step 4: Sanding
After you are done wrapping, you need to lightly sand the wires to have a good connection. It should show up as a light colored shiny gold.
Step 5: Add the Battery
Just tape one wire to the - (negative) and the other to the + (positive). As shown in the pictures.
Step 6: You're done!
Congrats! You've made your own mini heater, just put it in your pocket or in your car, and if you get cold...Just hold it in your hands!!! Hope you liked this instructable :)