Condenser Microphone Power Supply
Condenser Microphone Power Supply
Condenser Microphone Power Supply

Condenser Microphones typically sound better than dynamic microphones. If you are unfamiliar with these two types of microphones you may want to read about them in this Wikipedia article.

http://en.wikipedia.org/wiki/Microphones#Condenser_microphone

The short version is this:

Dynamic microphones have a coil and a magnet. So they act like little electric generators. They do not require external power such as a battery to operate.

Electret condenser microphones have to little plates (capacitor), one of which vibrates in the presence of sound. The varying capacitance is turned into an electrical audio signal by a tiny built in pre-amplifier. So this type of microphone needs an electric current to operate. Besides sounding good, condenser microphones typically have better sensitivity. Also condenser microphone elements are typically smaller than the dynamic type and many condenser microphone elements are very inexpensive.

If you have been thinking about experimenting with condenser microphone elements I would suggest this one:

http://www.radioshack.com/product/index.jsp?productId=2062215

As of today it is only $2.89.

I have an extra mic that is still in the package. On the back it has a tiny graph of the frequency response. If you go to the Shure microphone web site, you can look at the specs for there very popular SM58 microphone, The RadioShack micís upper frequency response actually looks flatter than the SM58 out to about 15 Khz. It would be helpful if the Radio shack graph had more resolution so we would know exactly where the upper frequency cut off actually is. It is actually well above the 10 Khz stated in the specs on the back of the package. Donít get me wrong. The SM58 is a great microphone for live performances where the performer is belting out a tune with the mic almost touching their face. SM58s are really rugged. If you like to swing your microphone around by itís mic cord and occasionally dropping it on the stage (Roger Daltrey) this is the microphone for you. I own two SM57s (same mic with a smaller wind screen). It just isnít the right microphone for some applications such as DIY audio projects. By the way. The SM58 will set you back about $100. The RadioShack mic is an ok vocal mic but a really good area mic. If you want to use it as a vocal mic you will need a foam wind screen.

Some audio equipment provides voltage at the microphone input jack so an external power supply is not needed for a condenser mic. Some equipment does not. Many off the shelf condenser microphones (complete microphone including and audio cable and connector or a connector that accepts a microphone cable) have a built in battery holder to power the microphone and some do not. So sometimes, depending on what condenser microphone you are using and what you are plugging into, you need a battery operated power supply or it will not work.

Here is one fun microphone project I did a long time ago which is one of the reasons why I made my first condenser microphone power supply. We used to feed our outdoor pets which were the wild birds. To add to the experience I wired up one of the radio shack mics onto a shielded audio cable and ran the other end into the house by closing the window on the cable (you can do this with a thin cable. The other end of the cable plugged into the power supply. The output of the power supply plugged into a battery operated audio amplifier. The microphone was attached to the underside of the covered patio roof and the food dish was on the patio, 8 feet below. We could hear all the tweeting as if we were outside next to the dish. We could also hear their little beaks tapping the bottom of the plastic dish. From time to time we could hear possums rustling around outside after dark and of course crickets. On a good night it was like camping out under the stars in the living room.




Step 1: Schematic

Condenser Microphone Power Supply

Here is the schematic diagram of the circuit. The circuit on the back of the package says to use a resistor up to 1k. I tried different resistors and decided to go with 10k. The battery last for days of continuous use. Probably 10 times longer than using a 1k and it sounds great. I will test the run time at a later date. There are a range of capacitors that will work. The smaller the capacitance the more treble you get and you get less bass. I did some testing with capacitors as small as 0.001 uf and as large as 0..47 uf. I went with 0.01 uf. You may want to experiment with different values. What I settled on is not high fidelity but high clarity for speaking, birds and crickets (no bass and lots of treble)..

Step 2: Part Layout

Condenser Microphone Power Supply
Condenser Microphone Power Supply

Here is a diagram with the part layout.

Step 3: Polarity

Condenser Microphone Power Supply
Condenser Microphone Power Supply

The microphone has polarity (+ and -) The minus (negative) wire is the one that connects to the metal case.

The positive (+) connection On the RCA plug is the terminal that connects to the center pin. The other terminal is negative (-).

Step 4: Microphones

Condenser Microphone Power Supply

Here are a few condenser microphones I have wired up. Not pictured is the hair brush mic.

Step 5: Guitar Amplifier Setup

Condenser Microphone Power Supply

Here is a set up that will work well for bringing the sounds in your backyard indoors. The video cable will require drilling a hole in the wall. Video cable typically works good as an audio cable. There is a limit to the length of cable you can run with this set up. Pictured is a 50 foot cable that worked fine. Off the shelf video cables require adapters to connect the F type video connectors to RCA connectors. The amplifier is First Act model MA104. I do not think these are made any more but you can still get them on Ebay.

The connections pictured are as follows. The microphone is connected to one end of the video cable, the other end is connected to the input of the power supply. The output of the power supply is connected to the input on the guitar amplifier.

Step 6: 14 volts DC

Condenser Microphone Power Supply

It is handy to have an amp that uses an AC adapter to power it up. This one is ideal if you want to go off grid or power it up from a car cigarette lighter socket. You just need to make a cable.

Step 7: As Seen On TV

Condenser Microphone Power Supply

As seen on TV connected to the RadioShack battery operated amplifier.

Thanks to PJ over at

http://www.prepper-resources.com/

For suggesting that I do this instructable. He has a lot of good ideas.

Step 8: Updates

Condenser Microphone Power Supply
Condenser Microphone Power Supply

The picture shows the microphone with a RadioShack windscreen. Here is the information on the windscreen which I picked up at my local RadioShack.

http://www.radioshack.com/product/index.jsp?productId=2103337

?

?

?

?

Step 9:

Sample audio file from many years ago (just for fun).

Condenser Microphone Power Supply
hawaii.wav1 MB
 
 

Tag cloud

make build easy simple arduino making homemade solar laser printed portable cheap mini building custom cardboard wooden create super lego turn paracord chocolate your paper light intel