Arduino Based Disco Lights

This tutorial demonstrate the basics of Arduino with using two led lights which blink sequentially.

Step 1: Parts Required

Arduino Based Disco Lights

You will require the following parts :---

1) Arduino Uno ( You can use any version of Arduino )

2) 2 Led's

3)Breadboard

4) Breadboard Wires

5) Wire Stripper

Step 2: About Fixing Led's

The Led operate at 3V DC. The led's can be easily drawn by Arduino board. It has to be remembered that the shorter leg of an led is - negative & longer led is + positive.

Fix the Led as shown in image.

Step 3: Connecting Led to BreadBoard

Arduino Based Disco Lights

1) Connect the ground of Led's to GND Pin of Arduino.

2) Connect +ve of one Led to 12th Pin of Arduino.

3) Connect -ve of second Led to 11th Pin of Arduino

4) Connect the USB Cable from computer to Arduino

Step 4: Disco Light Program

Below is the code for running disco lights using Two Led's. Upload the code to Arduino :---

/*
Disco Lights Turns on 1st LED on for one second, then 2nd Led for one second, repeatedly.

*/

void setup() {

// initialize the digital pin as an output.

// Pin 12 & 11 have LED's+ connected.

pinMode(12, OUTPUT);

pinMode(11, OUTPUT);

}

void loop() {

digitalWrite(12, HIGH); // set the LED on 12th Pin on

digitalWrite(11, LOW); // set the LED on 11th Pin off

delay(1000); // wait for a second

digitalWrite(12, LOW ); // set the LED on 12th Pin off

digitalWrite(11, HIGH); // set the LED on 11th Pin on

delay(1000); // wait for a second

}

Step 5: I am a Disco Dancer...

Arduino Based Disco Lights
Arduino Based Disco Lights

Hurray !!!! The Disco lights have been started.

 
 

Tag cloud

make build easy simple arduino making homemade solar laser printed portable cheap mini building custom cardboard wooden create super lego turn paracord chocolate your paper light intel